The Boarding Bar

- Make cruising more fun: never have to crawl, wiggle or flop into or out of your dink again!
- Be comfortable "commuting" to shore from a mooring, and SAVE 75% of dock costs.





ding-ez - always EZ to reach

EZ-in, EZ-out of ANY inflatable boat.
1- Flat-floor hard bottom: The bar is anchored to a floor-mount hinge that is affixed to the floor with the 3M product 5200.
2- V-Floor hard bottom: The bar is anchored on small rails that are affixed to the V-floor with the 3M product 5200.
3- Soft-floor & roll-ups use a hinge system, securely fastened to the transom and pontoons.

All ding-ez boarding systems come pre-cut, pre-drilled, and pre-finished,
ready to glue and bolt in place. It's EZ!

To a Flat-Floor, Hard Bottom Inflatable - The hinges are easily fastened to the deck with the same technique used universally to install seats and consoles. They are permanently sealed with 3M's 5200.

Heavy duty option - Hard-bottom RIB only. Combines a soft hull harness with a cross stabilizer and feet to the floor.

To a V-Floor, Hard Bottom inflatable - The hinges fasten to small rails that are easily affixed to the V-floor with the 3M product 5200. Hull is thru-bolted, sealed with 5200.

To a soft-hull or roll-up inflatable - a harness rail runs along each pontoon, from a glue-on pad amidships, aft to the transom. The hinge is attached to the harness rail. Ding-ez is making its own super strong polyurethane glue-on pads.

Bow bar - fastened to sockets on a bow seat or bow step in a hard bottom inflatable, allows assisted entry and exit over the bow of the boat.

 

Custom orders can be accommodated.